Kohla Transfer tape Smart Glue glue for skialp belts, 50 m
At the beginning of each season, it is a good idea to check the condition of the belts - the stickiness of the glue and the condition of the toe and heel. If the glue does not hold well, is torn in some places, dirty from needles or other dirt, the glue must be replaced. This is the purpose of this replacement Smart Glue adhesive in a roll, which can be used to restore the adhesive layer of the climbing belt in a simple way. Roll 50 m for service centers or ski clubs.
The procedure for restoring the adhesive of the climbing belt
- Remove the old layer of glue - using a heat gun and a scraper. You heat the old glue with a gun or a powerful hair dryer, which you then scrape away from the belt with a scraper. Or the second way, using an iron and an absorbent material (an old cotton t-shirt), when you pass a hot iron over the t-shirt, placed over the old glue, and the glue is gradually absorbed into the t-shirt.
- Place the film with the new adhesive on the cleaned belt along its entire length with the transparent part towards the belt.
- Using an iron at a temperature of approx. 150 ° C, iron the glue evenly into the belt.
- Allow the glue to cool and dry thoroughly (even for several hours) and only after it has cooled, remove the foil from the strip.
- Remove the excess glue from the edges.
Width | 135 mm |
product ID | 184746 |

There are currently no reviews