Fenix ​​E35R + AOD-S V2.0 rechargeable lamp

The Fenix ​​E35R rechargeable flashlight offers a luminous flux of up to 3100 lumens (ANSI) and an afterglow of up to 260 meters. Excellent performance was achieved using the modern LED Luminus SST-70. It is powered by a high-capacity Li-ion battery type 21700 with a capacity of 5000 mAh. It is recharged via the USB-C connector on the side of the lamp. The E35R replaces the popular E35 V3.0 lamp, but it also has a built-in charging connector and a magnetic terminal. The lamp was designed with ease of use and wide applicability in mind. Six light functions allow you to choose between high performance and a duration of more than two and a half days. There is also a blinding strobe for emergencies. The Fenix ​​E35R is powered by a digitally regulated constant current to guarantee constant light output even when the voltage in the batteries is reduced (while they are slowly discharged). The lamp is equipped with an ultra-thin collimator, which is made using technologies from the automotive industry. Switching on and switching modes is done with the button ergonomically placed on the side. The magnet in the end is practical, the lamp can be attached to iron objects.

This lamp is an ideal lighting tool with an excellent ratio of high performance, quality and price. We can recommend it for a wide range of outdoor, sports, work and professional activities.

All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard. 

Parameters of the Fenix ​​E35R rechargeable lamp

• The Luminus SST-70 premium LED with a lifespan of 50,000 hours is used.
• Six power modes: 3100 lumens (2.5 hours) -> 1000 lumens (3.67 hours) -> 350 lumens (9.3 hours) -> 150 lumens (21.3 hours) -> 30 lumens ( 69 hours ) - Stroboscope with variable frequency (3100 lumens).
• Luminous flux and duration times are measured with the included Li-ion battery 21700 with a capacity of 5000 mAh.
• The lamp has a memory and turns on in the last selected mode (only applies to the 30, 150 and 350 lumen modes).
• Electronics with digital constant regulation and intelligent protection against overheating.
• Made of aircraft-grade hardened aluminum type T6, the lamp is impact-resistant when dropped from a height of 1 meter.
• Protection against accidentally inserting the battery upside down (reverse polarity).
• Durable surface - Type III hard anodized.
• Battery charge status indicator built into the button.
• Waterproof according to the IP68 standard (tested under water at a depth of 2 meters).
• Unique super-thin collimator for a perfect light cone with an afterglow of 260 meters (15103 cd).
• Dimensions 12 cm (length) x 2.65 cm (diameter).
• Weight 148 grams with battery.
• The flashlight comes with a Fenix ​​ARB-L21-5000 V2.0 battery, a USB-C charging cable, a wrist strap and a spare o-ring.
• Models from the E series are supplied without a case. This basic case can be purchased separately.
• As optional original accessories, it is possible to purchase: diffuser AOD-S V2.0, strap Fenix ​​ALD-05 for use of the light on the helmet, rotating case for the belt, holder for the bike, holder for the Fenix ​​bike, USB adapter for the mains and USB adapter for cars.
• LockBlocks bicycle holder, BikeBlock bicycle helmet holder are also compatible with the lamp.

Use of Fenix ​​E35R work light

From the factory, there may be an insulating cap inside the lamp on the battery. Remove it from the battery before first use.

To turn it on or off, hold down the side button for about 0.5 seconds, the lamp will always turn on in the last selected mode, with the exception of the two highest ones (turbo and high). You can switch power modes at any time during operation by pressing the side button. The stroboscope can be activated by holding down the button for 1.2 seconds (the lamp must be switched on). When the button is released, the strobe will turn off.

Charging - unfold the rubber cover of the charging connector on the side of the lamp and plug in the attached cable (USB-C connector), plug the other end of the cable into the computer, or the USB adapter into the electrical network or the car. During charging, the indicator LED lights up red. It lights up green when fully charged. Charging a fully discharged battery takes about 3 hours (with a 2A power supply). 30, 150 and 350 lumen modes can be used while charging.

Intelligent protection against overheating - If the temperature exceeds 60°C, there will be an automatic reduction in performance. As soon as the temperature drops below 60°C, it is possible to use the highest power again.

Battery charge status indication - after a short press of the button (the lamp must be switched off), the LED indicator in the button is activated. If the indicator light is green, the battery is charged to more than 85%. Green flashing means 50-85% capacity. If it lights up red, it is charged to 25-50%. Blinking red means there is less than 25% battery capacity left.

Locking the button - if you want to prevent unwanted switching on of the lamp in the luggage, press the button twice quickly for 0.5 seconds (the lamp must be turned off), then the lamp will flash twice in low mode and cannot be turned on. To unlock, quickly double-press the button again. Unwanted switching on can also be prevented by enabling the lamp body.

Warning about the discharged battery - the side button starts to flash red and the lamp gradually automatically switches to the lowest mode.

Warning

• Do not disassemble the sealed part in the lamp head yourself, this will void the warranty.
• Use only high-quality Li-ion batteries 21700 to avoid damage to the lamp, for example due to leakage of substances from the battery.
• If the protective rubber rings appear damaged after a long period of use, replace them. The rings must also be lubricated to prevent rubber erosion. By following these rules, the lamp will be properly protected against water.
• If the lamp flashes, does not switch to higher power, or does not light up, it may be for one of the following reasons:
  
  • The battery is dead, charge it.
  • The contacts inside the lamp are dirty - clean them with a cotton swab dipped in alcohol.
  • The lamp body is loose, tighten it.

Output: 3100lm
Max. durability: 69 hours
Aftersight: 260m
Number of modes: 6
Weight: 148g
Power supply: 1x 21700
Light source: Luminus SST-70
Waterproof: IP68 (immersion 2 m)