Fenix WF05E ATEX lamp

Professional lamp Fenix ​​WF05E with ATEX/IEC certification for use in explosive environments. The lamp is powered by two micro-pencil (AAA) batteries and provides a luminous flux of up to 85 lumens. The body of the lamp is made of aluminum alloy for high durability and impact resistance, and the buckle is made of antistatic plastic. The lamp is mainly intended for firefighters, rescuers, use in chemical, oil, textile and metallurgical operations and other areas where ordinary lights cannot be used. It resembles a pen in shape and can be carried in a breast pocket, for example. The lamp is not intended for use in mines.

Certificates:

• Usable in zones 1-2 of explosive gases and in zones 21-22 of explosive dust
• Full text of the certificate:
  
  
  • IECEx: Ex ib IIC T4 Gb, Ex ib IIIC T130°C Db IP66/IP68
  • ATEX: II 2G Ex ib IIC T4 Gb, II 2D Ex ib IIIC T130°C Db IP66/IP68
  • CSA: Ex ib IIC T4 Gb IP66/IP68; Class I, Zone 1, AEx and IIC T4 Gb
    
    Ex ib IIIC T130°C Db IP66/IP68, Zone 21, AEx ib IIIC T130°C Db IP66/IP68

Parameters of the Fenix ​​WF05E explosion hazard lamp :

• A powerful Cree XP-G2 LED with a lifespan of 50,000 hours of light is used.

• Three power mode: 85 lumens (11.5 hours) -> 30 lumens (35 hours) -> 10 lumens (80 hours).

• It uses two micro-pencil (AAA) batteries. The manufacturer strongly recommends using only the following types of batteries that have been certified for use in the lamp: Energizer E92, Duracell MN2400 and Panasonic LR03XWA

• Protection against accidentally inserting the battery upside down (reverse polarity).

• Made of aviation hardened aluminum, durable surface - Type III hard anodized.

• Grooving surface for better grip.

• Waterproof and dustproof according to the IP68 standard.

• Smooth aluminum reflector for a perfect light cone with an afterglow of up to 54 meters (724 cd).

• Dimensions 13.45 cm (length) x 1.9 cm (head diameter) x 1.49 cm (body diameter).

• Weight 38 grams (without batteries).

• Included in the package are two Energizer E92 micro-pencil alkaline batteries, which are approved for use in the lamp, a spare o-ring and a strap.

To use :

To turn on the lamp, turn the reflector clockwise (tightening the head), the lamp will always turn on in medium power mode. Turning it in the opposite direction turns the flashlight off again (head release). To change the intensity of brightness, quickly turn off the lamp from the on state and turn it on again. This switches the luminaire to the next level of output power.

Notice:

• Carry out all service work and battery replacement outside of an explosive atmosphere!

• Never mix batteries of different manufacturers, different ages or different degrees of discharge.

• For long-term storage, we recommend removing the batteries from the lamp to prevent them from leaking and damaging the lamp.

• If the protective rubber rings appear damaged after a long period of use, replace them.

• If the light flickers, does not switch to higher power modes, or does not light up, it may be for one of the following reasons:

  • Batteries are almost empty - replace them.

  • The contacts inside the lamp are clogged - clean them with a cotton swab dipped in alcohol.

Warranty

Five-year warranty.

Output: 85lm

Max endurance: 80 hours

Aftersight: 54m

Number of modes: 3

Weight: 38g

Power supply: 2x AAA

Light source: Cree XP-G2

Waterproof: IP68 (immersion 2 m)