Kohla Glue iron-on renovation glue 130 mm/50m
At the beginning of each season, it is a good idea to check the condition of the belts - the stickiness of the glue and the condition of the toe and heel. If the glue does not hold well, is torn in some places, dirty from needles or other dirt, the glue must be replaced. This is what this replacement Glue in a roll is for, with the help of which the adhesive layer of the climbing belt can be restored in a simple way
- supplied in a length of 4 m
- width 130 mm
- glue type Glue
One 4 m roll is usually enough to renew the glue for both strips.
The procedure for restoring the adhesive of the climbing belt
- Remove the old layer of glue - either by using a heat gun or a scraper. You heat the old glue with a gun or a powerful hair dryer, which you then scrape away from the belt with a scraper. The second method is using an iron and an absorbent material (an old cotton t-shirt), when you pass a hot iron over the t-shirt, placed over the old glue, and the glue is gradually absorbed into the t-shirt.
- Place the film with the new adhesive on the cleaned belt along its entire length with the transparent part towards the belt.
- Using an iron at a temperature of approx. 150°C, iron the glue evenly into the belt.
- Allow the glue to cool and dry thoroughly (even for several hours) and only after it has cooled, remove the foil from the strip.
- Remove the excess glue from the edges.
To extend the life of the glue, it is advisable to use a separation film, which is included in the package of KOHLA riser adhesive strips or can be purchased.
Sport | ski mountaineering |
Material | unspecified |
Colour | yellow |
product ID | 183517 |
There are currently no reviews