Fenix ​​WT16R rechargeable LED lamp

Fenix WT16R is a multi-purpose rechargeable lamp with a remote reflector and a wide side light with a power of up to 300 lumens. The light source in the remote reflector is a pair of Cree XP-E2 LEDs, the side light contains several COB LEDs. This side light has a wide light cone with uniform intensity, which is ideal not only for workplace lighting, but also has a yellow flashing warning function. The Fenix WT16R lamp is also equipped with a strong steel clip for easy carrying on a belt or pocket. It is also equipped with two strong magnets, one is located on the side and the other on the bottom. The lamp can thus be easily attached to the iron surface in two different positions. Due to its variability, the lamp is designed specifically for work use, but it will also work well in the home and when camping.

The lamp is powered by a built-in lithium-polymer battery 3.7 V / 2000 mAh, which is charged with a cable via a USB-C connector (the cable is included in the package).

All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

Parameters of the Fenix WT16R LED work light

• Powerful Cree XP-E2 and COB LEDs with a lifespan of 50,000 hours are used.
• Six performance modes:
  
  • Remote reflector: 300 lumens (3.8 hours) -> 100 lumens (9.3 hours) -> 30 lumens ( 30 hours ).
  • Side wide light: 300 lumens (3.8 hours) -> 100 lumens (9.3 hours) -> yellow flashing (10 lumens).
• Digitally regulated for constant brightness, the electronics remember the last set mode.
• It uses a built-in Lithium-polymer battery 3.7 V / 2000 mAh, which is charged via the USB-C connector on the lamp.
• It supports fast charging, full charge in 1 hour and 40 minutes with 2A USB power source.
• High beam afterglow 115 meters (3200 cd), side wide beam afterglow 23 meters (130 cd).
• Indication of the state of charge of the accumulator.
• Dimensions 12.7 cm (length) x 3.7 cm (width) x 2.6 cm (height).
• Weight 129 grams (including battery).
• Made of impact-resistant plastic.
• Impact-resistant from a fall from a height of 1 meter.
• Waterproof according to the IP66 standard.
• Two magnets on the back and side of the lamp - the lamp can be attached to anything iron.
• The package includes a lamp with a rechargeable battery, a USB-C cable and a wrist strap.
• The lamp can also be purchased with a USB adapter for the mains and a USB adapter for the car.

Use of Fenix WT16R LED lamp

The flashlight is turned on and off by pressing the button for 0.5 seconds, as soon as it is on, the lighting modes are switched by pressing it briefly. Hold the button for 1.2 seconds to switch between high beam and side wide beam. The lamp has a memory and after being turned on again, it will always turn on in the last light mode.

The control button can be locked so that it does not turn on by itself, e.g. when transported in luggage. When the lamp is off, press the control button twice quickly (within 0.5 seconds), the lamp will then flash twice, signaling the lock. To unlock, quickly press the button twice again.

Protection against overheating: when operating at maximum power, the lamp will gradually reduce the luminous flux after five minutes to 200 lumens when using the long-distance reflector, or to 150 lumens when using the side reflector.

The lamp is charged using a USB-C connector, which can be plugged into a computer, a power bank, a USB adapter to the mains or a USB car adapter. The indicator light next to the button lights up red during charging and turns green when fully charged. A full charge takes approximately 1 hour and 40 minutes using a 2 A source.

Indication of the state of charge: After a short press of the button (the lamp must be switched off), the LED indicator of the state of charge of the batteries next to the button is activated. A green light indicates that the battery is more than 85% charged, a green flashing light indicates 50-85%, a red light indicates 25-50%, and a red flashing light indicates that the battery is less than 25% charged.

Warning

• Do not disassemble the lamp yourself, this will void the warranty.
• If the lamp flashes or does not light up, it may be for one of the following reasons:
  
  • The battery is discharged - charge it.

Warranty

Warranty two years.

Aftersight: 115m
Number of modes: 6
Weight: 129g
Max endurance: 30 hours
Output: 300lm
Power supply: Internal accumulator
Power supply: USB charging
Light source: Cree XP-E2
Waterproof: IP66 (heavy rain)