Fenix ​​TK75 4xCree XHP35 HI + 4x 3500 mAh batteries

Tip: Are you opting for a searchlight? The article Comparison of ultra-powerful Fenix ​​searchlights will help you with your choice.

Affordable set of Fenix ​​TK75 Cree XHP35 HI flashlight and four Fenix ​​18650 3500 mAh rechargeable Li-ion batteries. Ušetríte 7,60€!

Already the fourth generation of the extremely powerful lamp Fenix ​​TK75 brings an increased luminous flux of up to 5100 lumens ( ANSI) and an afterglow of up to 850 meters. 4 state-of-the-art Cree XHP35 HI LEDs are used as a light source. Thanks to the use of modern 18650 li-ion batteries, the lamp has surprisingly compact dimensions - only 18.8 centimeters in length. The lamp offers a total of eight constantly regulated power levels, including two flash modes, strobe and SOS. For convenient control, the lamp is equipped with two buttons on the side.

Compared to the previous version, the option of charging batteries via micro USB directly in the battery holder has been added. This searchlight is suitable, for example, for reconnaissance and rescue operations, for movement in difficult and unclear terrain and for all those who demand the highest performance. ANSI / NEMA FL 1-2009.

All lamp parameters (luminous flux, battery operation time, waterproofing, afterglow and impact resistance) are measured in accordance with the ANSI/NEMA FL 1-2009 standard.

Fenix ​​TK75 4xCree XHP35 HI flashlight parameters

• The light source is four state-of-the-art Cree XHP35 HI LEDs with a lifespan of 50,000 hours.

• Five power modes in total: 5100 lumens (2.25 hours) -> 2000 lumens (3 hours) -> 1000 lumens (6 hours) -> 450 lumens (17.75 hours) -> 150 lumens (46 hours) -> 50 lumens (95 hours) -> Strobe 5100 lumens (strobe flashing with variable frequency) -> SOS 150 lumens (270 hours).
  Endurance times are measured with rechargeable Fenix ​​li-ion batteries with a capacity of 3500mAh.

• It is possible to use 4x Li-ion batteries of type 18650 for power supply (they are not part of the package). The possibility of charging the batteries via the micro USB connector directly in the battery holder.

• Due to the mechanical protection against polarity reversal, the accumulators must have the positive pole exposed. Older Fenix ​​batteries with a flat plus pole cannot therefore be used.

• In an emergency, it is possible to power the light with only two 18650 batteries, but the lamp will only work in the lowest mode. It is also possible to use 4x or 8x CR123A batteries, but the lamp will only work in one mode and it will not be possible to switch modes.

• Digitally regulated for constant brightness. Intelligent protection against overheating.

• Battery charge status indication.

• The four-part smooth parabolic reflector creates a light cone with an extreme afterglow of up to 850 meters ( 180600 cd).

• The electronics is equipped with a protective function against excessive battery discharge, when the voltage drops below a certain threshold, it automatically switches to a lower power mode.

• The lamp has a memory and will always turn on in the last set mode (does not apply to flash modes).

• Protection against accidentally inserting the battery upside down (reverse polarity).

• Dimensions: 18.8 cm (length) x 5.3 cm (body diameter) x 8.6 cm (reflector diameter).

• Weight: 630 grams (without battery).

• Made of aircraft-grade hardened aluminum, the lamp head is complemented by a stainless steel impact rim.

• Durable hard-to-scratch surface - Type III hard anodized.

• Impact-resistant from a fall from a height of 1 meter.

• Waterproof according to the IPX-8 standard (tested under water at a depth of 2 meters for 30 minutes).

• Hardened ultra clear glass lens with anti-reflective coating.

• Trapezoidal threads with increased wear resistance.

• Able to stand on its own on a flat place and serve as a candle.

• The body is equipped with a thread for screwing on a tripod.

• Prominent indentation over the entire surface of the lamp for better holding.

• A shoulder strap, hand loop, charging USB cable and spare o-rings are included with the lamp.

• Batteries are included in the package .​​

• The lamp can also be purchased with a USB adapter for the mains, a USB adapter for the car and a USB adapter supporting fast charging.

The use

Hold down the right button to turn on the flashlight and with further presses you switch between permanent power modes, holding it down again turns it off. Press the left button to activate the strobe and press again to activate the SOS mode. You can get back to the last constant light mode by pressing the right button. Holding down the right button for 1.2 seconds will turn the light straight into Turbo mode 5100 lumens (when the light is off). By holding down the left button for about 0.5 seconds, you turn on the light directly into the stroboscope.

Battery capacity indication (valid only when powered by 18650 li-ion batteries) - after a short press of the left button (the lamp must be switched off), the LED indicator between the buttons is activated for three seconds. If the indicator light is green, the battery is charged to more than 80%. Green flashing means 50-80% capacity. If it lights up red, it is charged to 20-50%. Blinking red means there is less than 20% battery capacity left. The state of charge of the batteries can also be checked by pressing the blue button on the top of the battery holder.

Nabíjanie - vyberte držiak batérií zo svietidla a zapojte priložený kábel do svietidla (konektor micro-USB), druhý koniec kábla zapojte do počítača, alebo USB adaptéra do elektrickej siete či auta (nie sú súčasťou balenia). During charging, the LED on the holder flashes red and lights up green when fully charged. The charging time for four completely discharged batteries with a capacity of 3500 mAh is approx. 8 hours when using a 2A source and approx. 11.5 hours when using a 1A source.

Upozornenie na vybité batérie - indikátor medzi tlačidlami sa rozsvieti na červeno. The lamp then automatically gradually switches to the lowest mode. The control buttons can be locked to prevent spontaneous activation, e.g. when transported in luggage - hold down the two buttons for 3 seconds. To unlock, hold both buttons again for 3 seconds.

The control buttons can be locked to prevent spontaneous activation, e.g. when transporting in luggage - keep both buttons pressed for 3 seconds. To unlock, hold both buttons again for 3 seconds.

Intelligent protection against overheating - if the lamp temperature rises above 65 °C, it automatically switches to a lower level.

Warning

• Do not disassemble the sealed parts of the lamp yourself, this will void the warranty.

• Use only high-quality 18650 batteries to avoid damage to the lamp, for example due to leakage of substances from the battery.

• If the protective rubber rings appear damaged after a long period of use, replace them. The rings must also be lubricated to prevent rubber erosion. By following these rules, the lamp will be properly protected against water.

• If the light flickers, does not switch to higher power modes or does not light up, it may be for one of the following reasons:

  • Batteries are low - replace them.

  • The contacts inside the lamp are dirty - clean them with a cotton swab dipped in alcohol.

  • The body or the back of the lamp is loose - add lubricant to the sealing rings and tighten.

Warranty

Five-year warranty.

Aftersight: 850m
Max endurance: 95 hours
Power: 5100lm
Number of modes: 8
Weight: 630g
Power supply: 4x 18650
Light source: Cree XHP35 HI
Waterproof: IP68 (immersion 2 m)