Mondraker mountain bike PRIME 29, SRAM, light blue/orange, 2019
frame: prime 29 xtralite full butted alloy, forward geometry
fork: RockShox judy with tk 29 solo air boost tapered, 120mm travel
head composition: ONOFF saturn acb bearings integrated tapered 1-1-8
derailleur: sram gx long leash, 10 speeds
shifting: modules sram x5 trigger 10 speed
brake levers: sram level t
cranks and converters: bosch performance line cx system W- powertube 500wh bosch battery, purion display. miranda delta cranks, length 165mm, 16 teeth
handlebars: Mondraker custom design 0.5, width 760mm
stem : ONOFF Stoic fg, length 30mm
seat post: ONOFF dropper drink internal 1x lever
saddle: Mondraker e-mtb custom design
front hub: dt swiss hybrid spiline 370S based 15x110mm
rear hub: dt swiss hybrid spiline 370S based Pawl system 12x148mm
chain: sram pc-1031 10 speeds
cassette: Sunrace csmcs2 11-42 teeth, 10 speeds
wires: hybrid system specific sp spoke
rims: dt swiss hybrid h1900 spline 29 30mm
tires: Kenda Nevegal for ii 29x2.4
Gears | 1x10 |
Drive | Bosch Performance CX |
Battery | 500 Wh |
product ID | 79594 |

All bicycles at the MTBIKER shop are new, not-ridden, from an official distributor and with a full warranty. Several brands even offer a lifetime warranty on the frame after registration. We perform all warranty services in MTBIKER stores after personal delivery or after sending the bike (or its part) by courier.
- The bicycle is taken out of the manufacturer's box
- The bicycle is assembled, inspected and adjusted (front and rear derailleur, shock, fork, wheels,...)
- The bicycle is carefully packed back into a box and shipped
- If you order a bicycle for in store pick up or home delivery, the bicycle will be waiting put together, checked and ready to use for you.
- If you order a bicycle via courier to your home address, the following must be done at home:
- Take the bike out of the box and carefully remove safety material and foils
- Mount handlebar to stem (1 minute, 4 or 5 mm hex hey is needed).
- Mount front wheel to fork (1 minute, without the need of any tools if the bike has a quick release).
- Loosen the screws in the headset, straighten the stem with the front wheel, tighten the upper screw on the fork and then tighten the headset (2 minutes, 4 or 5 mm hex key is needed).
- Mount the pedals to the cranks while lubricating the thread and carefully mounting it the right way (1 minute, 8 mm hex key or 15 mm wrench).
- Mount seatpost to frame (10 seconds, without needing any tools if the frame has a quick link).
- Inflate the tyres or fork and shock to desired pressure (2 minutes, pump needed).
- Check the tightening of hex keys and quick-releases (2 minutes, 4 and 5 mm hex key is needed).
- Go for a test drive! Handle your bicycle carefully until you get used to it. If the bike has disc brakes, their performance will be limited from now on - they will gain their full power after 4-5 strong brakes at higher speed.

There are currently no reviews