Giant XTC Advanced 29er3, 2018 model
Advanced Composite frame, horizontal feet
Suntour Raidon LO-R Air fork, 100 mm travel, 15x100 mm thru-axle, OverDrive column
Giant Connect Trail handlebars, 780 x 31.8mm
Giant Connect stem
Giant Connect seat post, diameter 27.2 mm, length 400 mm
Saddle Giant Contact (Forward)
Shifting Shimano Deore, gears 1x10
Derailleur Shimano Deore Shadow +
Brakes Shimano M365, discs 180 mm in front, 160 mm in the back
Shimano M365 brake levers
Shimano Deore cassette, 11-42 teeth
KMC X10 chain
Praxis Works Cadet cranks, 30 tooth derailleur
Praxis 90 PressFit center composition
Rims Giant XC-1 29 Wheelset, tubeless rims, 21 mm inner width
Hubs [Front] Giant Tracker , 15x100 mm thru-axle, sealed bearings, [Rear] Giant Tracker Boost, 12x148 mm thru-axle, sealed bearings
SAPI wires
Tires Maxxis IKON EXO TR 29x2.2, 60 TPI, tubeless
Model year | 2018 |
Gears | 1x10 |
Groupset | Shimano Deore |
Material | carbon fiber |
Brakes | Hydraulic disc brakes |
product ID | 76259 |
All bicycles at the MTBIKER shop are new, not-ridden, from an official distributor and with a full warranty. Several brands even offer a lifetime warranty on the frame after registration. We perform all warranty services in MTBIKER stores after personal delivery or after sending the bike (or its part) by courier.
- The bicycle is taken out of the manufacturer's box
- The bicycle is assembled, inspected and adjusted (front and rear derailleur, shock, fork, wheels,...)
- The bicycle is carefully packed back into a box and shipped
- If you order a bicycle for in store pick up or home delivery, the bicycle will be waiting put together, checked and ready to use for you.
- If you order a bicycle via courier to your home address, the following must be done at home:
- Take the bike out of the box and carefully remove safety material and foils
- Mount handlebar to stem (1 minute, 4 or 5 mm hex hey is needed).
- Mount front wheel to fork (1 minute, without the need of any tools if the bike has a quick release).
- Loosen the screws in the headset, straighten the stem with the front wheel, tighten the upper screw on the fork and then tighten the headset (2 minutes, 4 or 5 mm hex key is needed).
- Mount the pedals to the cranks while lubricating the thread and carefully mounting it the right way (1 minute, 8 mm hex key or 15 mm wrench).
- Mount seatpost to frame (10 seconds, without needing any tools if the frame has a quick link).
- Inflate the tyres or fork and shock to desired pressure (2 minutes, pump needed).
- Check the tightening of hex keys and quick-releases (2 minutes, 4 and 5 mm hex key is needed).
- Go for a test drive! Handle your bicycle carefully until you get used to it. If the bike has disc brakes, their performance will be limited from now on - they will gain their full power after 4-5 strong brakes at higher speed.

There are currently no reviews