Giant Terrago 29er 1 GE, model 2018
AluxX Aluminum frame
FOX 32 Rhythm fork, 100 mm travel, handlebar lockout, 15 mm thru axle
Giant Connect Trail handlebars, width 780 mm
Giant Connect stem
Giant Connect seat post, 30.9 mm, length 400 mm
Saddle Giant Contact (Neutral)
Pedals MTB Caged, 9/16"
Shifting Shimano Deore XT, gears 2x11
Shimano Deore XT derailleur
Derailleur Shimano Deore XT Shadow +
Brakes Shimano Deore XT, discs [front] 180 mm, [rear] 160 mm
Shimano Deore XT brake levers
Shimano SLX cassette, 11-42 teeth
KMC X11 chain
Shimano Deore XT cranks, 36/26 tooth gears
Shimano PressFit center composition
Rims Giant GX03V 29", 6061 Aluminum, double wall, 21 mm inner width
Hubs [front] Giant Tracker, sealed bearings, 15mm thru axle, [rear] Giant Tracker Sport, quick release
Stainless steel wires
Tires [front] Schwalbe Tough Tom Active 29x2.25, [rear] Schwalbe Rapid Rob Active 29x2.25
Model year | 2018 |
Gears | 2x11 |
Groupset | Shimano XT, Shimano SLX, Shimano Deore |
product ID | 76249 |
All bicycles at the MTBIKER shop are new, not-ridden, from an official distributor and with a full warranty. Several brands even offer a lifetime warranty on the frame after registration. We perform all warranty services in MTBIKER stores after personal delivery or after sending the bike (or its part) by courier.
- The bicycle is taken out of the manufacturer's box
- The bicycle is assembled, inspected and adjusted (front and rear derailleur, shock, fork, wheels,...)
- The bicycle is carefully packed back into a box and shipped
- If you order a bicycle for in store pick up or home delivery, the bicycle will be waiting put together, checked and ready to use for you.
- If you order a bicycle via courier to your home address, the following must be done at home:
- Take the bike out of the box and carefully remove safety material and foils
- Mount handlebar to stem (1 minute, 4 or 5 mm hex hey is needed).
- Mount front wheel to fork (1 minute, without the need of any tools if the bike has a quick release).
- Loosen the screws in the headset, straighten the stem with the front wheel, tighten the upper screw on the fork and then tighten the headset (2 minutes, 4 or 5 mm hex key is needed).
- Mount the pedals to the cranks while lubricating the thread and carefully mounting it the right way (1 minute, 8 mm hex key or 15 mm wrench).
- Mount seatpost to frame (10 seconds, without needing any tools if the frame has a quick link).
- Inflate the tyres or fork and shock to desired pressure (2 minutes, pump needed).
- Check the tightening of hex keys and quick-releases (2 minutes, 4 and 5 mm hex key is needed).
- Go for a test drive! Handle your bicycle carefully until you get used to it. If the bike has disc brakes, their performance will be limited from now on - they will gain their full power after 4-5 strong brakes at higher speed.
