MONGOOSE Chamber BMX bike, model 2013
Fork- Full Chromoly, 1 1/8 "
Rims - Alloy 36 holes
Hubs- (F) Alloy with 3/8 "Axle, Loose Ball Bearing, 36 holes; (R) 14MM Axle, Sealed bearing cassette, 9T Driver, 36 holes
Tip- 14G Stainless
Tires- Innova 20 X 2.25 (F); 20 X 2.0 (R)
Pedals- Odyssey Twisted PC
Cranks- Full Chromoly 48-spline 3-piece Tubular 175MM, 25T Alloy "MOTOMAG" design
Middle composition - Sealed, MID, 19MM
Chain- KMC HP1
Cassette- 9T Driver
Handlebars- HI-TEN 8.25 "rise
Predstavec- Front load 50MM reach
Head assembly - Threadless Intregrated, 1 1/8 "
Brakes- (F) Tektro Alloy Caliper, (R) Alloy U-Brake
Brake levers- Rush Alloy
Seat- Mongoose Pivotal
Seatpost- Pivotal Steel, 25.4 X 200
Color- Metallic brown
Extra- Odyssey chase hawk grips
Model year | 2013 |
product ID | 3715 |
All bicycles at the MTBIKER shop are new, not-ridden, from an official distributor and with a full warranty. Several brands even offer a lifetime warranty on the frame after registration. We perform all warranty services in MTBIKER stores after personal delivery or after sending the bike (or its part) by courier.
- The bicycle is taken out of the manufacturer's box
- The bicycle is assembled, inspected and adjusted (front and rear derailleur, shock, fork, wheels,...)
- The bicycle is carefully packed back into a box and shipped
- If you order a bicycle for in store pick up or home delivery, the bicycle will be waiting put together, checked and ready to use for you.
- If you order a bicycle via courier to your home address, the following must be done at home:
- Take the bike out of the box and carefully remove safety material and foils
- Mount handlebar to stem (1 minute, 4 or 5 mm hex hey is needed).
- Mount front wheel to fork (1 minute, without the need of any tools if the bike has a quick release).
- Loosen the screws in the headset, straighten the stem with the front wheel, tighten the upper screw on the fork and then tighten the headset (2 minutes, 4 or 5 mm hex key is needed).
- Mount the pedals to the cranks while lubricating the thread and carefully mounting it the right way (1 minute, 8 mm hex key or 15 mm wrench).
- Mount seatpost to frame (10 seconds, without needing any tools if the frame has a quick link).
- Inflate the tyres or fork and shock to desired pressure (2 minutes, pump needed).
- Check the tightening of hex keys and quick-releases (2 minutes, 4 and 5 mm hex key is needed).
- Go for a test drive! Handle your bicycle carefully until you get used to it. If the bike has disc brakes, their performance will be limited from now on - they will gain their full power after 4-5 strong brakes at higher speed.

There are currently no reviews