Muc-Off Tubeless Kit - DH/Trail/Enduro set for tubeless conversion
Set for installing 2 tubeless MTB tires on rims with a width of 28-30 mm.
Muc-Off Tubeless Kit - DH / Trail / Enduro is a set for installing 2 tubeless tires on MTB on rims with a width of 28-30 mm.
The set includes:
Muc-Off Tubeless Rim Tape 10m x 30mm (rim tape, length 10m, width 30mm)
Seal Patches 2 pcs
CNN MACHINED Tubeless Valves black 44 m (2 pcs of tubeless valves in black color, length 44 mm) 2 pcs
No Puncture Hassle Tubeless Sealant 140 ml (2 pcs of tubeless sealant)
Use: DH/Trail/Enduro
Width in mm: 30 mm
Manual:
- Remove any old strip or tape and clean it.
- Make sure the edge is clean and dry before applying the tape.
- Take the tape from the packet and align it from the opposite side of the valve.
- Start by unrolling a small amount of tape and pressing down with your thumb or finger to hold it down.
- Continue to hold while you pull the tape off and stick firmly, once you have a few cm on the tape the tape will stick and holding is no longer necessary.
- Continue all the way around the edge (if it has a large concave layer, you can pull and roll the tape to fill all the edges).
- Overlap the tape by approximately 10-15 cm.
- Leave a small amount unglued so you can cut off the rest.
- After cutting out the outline and pulling the tape down, create a seal.
- Run your thumb around the edge and make sure there are no air pockets or dirty spots.
- Once you're happy with how it looks, use a small pin to locate the hole for the valve and cleanly pierce the tape ready for the valve.
- Grab your tubeless valve and remove the retaining ring and the ring.
- Choose the correct rubber joint for the rim tape and insert the valve into the rim.
- Install the O-ring and snap ring to secure the valve lock (do not overtighten, as this may damage the rubber).
- Remount the tire of your choice so as not to damage the tape (using tire levers, etc.).
- Inflate the tire to shape (you should hear a popping sound around the rim).
- Bleed the air and remove the valve core using the spare valve cap.
- Grab the bag of putty and shake it.
- Unscrew the cap and put the valve on the valve in the right position.
- While holding the bag, rotate the wheel down so that the bag is now upside down.
- Insert the sealant by rolling the bag down.
- Turn the wheel back to the right and remove the bag.
- Reinsert the valve core and inflate it to your pressure.
| product ID | 107455 |
-10% Park Tool Park Too mounting steel levers Heavy Duty TL-5
25.99 €
-10%
RRP 28.99 €
We are the largest cycling e-shop in Slovakia proven by 100,000+ customers.
We are available via email, online chat, phone or in person at our MTBIKER stores.
Thanks to your order we can support cycling development.
The payment process is safe and we offer you a wide range of options.
We will reward you for your purchase and also for quality contributions in the MTBIKER forum, e-shop, trips and photo gallery.
Visit our store with a pump-track and trail access or our showroom in a historical bulding in central Bratislava.
